I know you recommend using a temple (stretcher) when you weave. I have had terrible luck doing that.
How do you determine sett for boundweave, a weft-faced weave?
Madelyn helps a weaver find good resources for warping her sectional warp beam.
Corrected treadling for a figure in "The Draft: Tied Overshot" where the treadling and drawdown did not match. Get the corrected figure here.
Patterning in half dukagång is usually done with pick-up rather than with loom-controlled blocks, but structurally it is the same as a version of summer and winter in which only one tie-down shaft is raised throughout.
Read Madelyn's advice on how to pick the right loom for weaving runners or other projects.
If you have an 8-shaft loom but a project that only calls for 4, what do you do? Can you just ignore the extra shafts, or must you change your threading?
